Power UNITS FOR LIFT TABLE 1
Standard Description
This electrical power unit is developed exclusively for that small lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become broadly made use of during the marketplace of logistic products which include minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed by the solenoid valve together with the velocity managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is intended exclusively for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as velocity managed by the adjustable needle valve. When the lift rises to a large positoin, but the energy supply is lower, the decreasing movement is managed through the guide override function.
Power UNITS FOR LIFT TABLE three
General Description
This energy unit is made exclusively to the large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the velocity controlled by a stress compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE four
Basic Description
This power unit is developed exclusively for the big lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the velocity controlled by the adjustable needle valve. When the lift rises to a high positoin, but the energy supply is lower, the reducing movement is controlled from the manual override function.
Particular Notes
one. This power unit is of S3 duty cycle, which may only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic parts concerned prior to set up of the power unit.
three. Viscosity of the oil shoud be 15~46 cst,which need to also be clean and totally free of impurities.N46 hydraulic oil is suggested.
4. Oil modifying is required just after the preliminary a hundred operation hrs,afterwards after every 3000 hours.
5. The electrical power unit proven is built to be mounted vertically.