Spiral bevel gears are typically made from hardened steel. The teeth of these gears are often ground for a far more precise finish allowing for little noise at high speeds. You can specify left hand or right hand based on the spiral gear china direction you have to run the gears

If you have a high speed application that will require a lot of torque then spiral bevel gears are a great option. The gears operate at 90° to one another and have “spiral” shaped teeth which provides maximum tooth surface get in touch with while rotating. With get in touch with spread over the whole tooth the spiral bevel gear could be run much faster compared to the straight tooth bevel gear and handle harder starts and stops.

We make spiral bevel gears only for industrial applications.

Worm gears are found in large equipment reductions. Gear ratio ranges of 5:1 to 300:1 are typical. The setup is designed to ensure that the worm can turn the gear, however the gear cannot turn the worm. The position of the worm is shallow and as a result the apparatus is held in place because of the friction between your two. The equipment is found in applications such as for example conveyor systems where the locking feature can become a brake or an emergency stop.

The model cross-section shows a typical placement and use of a worm gear. Worm gears have got an inherent safety mechanism built-in to its style given that they cannot function in the invert direction.